Some portable speakers produce less-than-impressive bass. Not the JBL Charge. The JBL Charge stereo speaker plays from either a vertical or horizontal position, so you can use it in a variety of locations. And it fits easily into a backpack, so you can take it from one place to the next. From its rugged case and grille to the rubber end rings and a rubber cap for its USB port, the JBL Charge has the durability that your active lifestyle demands.
It can even charge your other mobile devices on the go with its built-in USB port. Ideal for active, outdoor lifestyles, the portable JBL Charge speaker fits into a backpack and plays from either a vertical or horizontal position, so you can use it just about anywhere. The JBL Charge stereo speaker is a portable audio powerhouse for any environment.
Products purchased online or from an authorized local retailer and under warranty may qualify for an exchange with a valid receipt. We noticed that you already have products in your cart.
In order to add spare parts we have to empty your current cart. We noticed that you already have spare parts in your cart. In order to add new products we have to empty your current cart. Factory Refurbished. JBL Charge. Alternate Views.This means almost everybody can have access to their favorite music on the go.
If you are already carrying music with you, you might want to listen to it anytime or anywhere, whenever your mood calls for it. Maybe you already carry a set of headphones with you everywhere. But sometimes you might also want to share your favorite music with other people. This is where a Bluetooth speaker fits in. Not only they are portable, but also they can be connected wirelessly to your smartphone or laptop devices saving you the hassle of messy wires.
Now come to the point. The Bluetooth speaker is operated via USB AC adaptor which connects to the ac outlet or built-in battery rechargeable. But, it still means you have to carry a charger with you for your speaker. But sometimes it may happen that you are looking for a way to go completely wireless. No matter what the reason is, we can help. The following are some ways you can charge instead of using a boring old charger:. It is always easier to carry a micro USB cable.
Plus, you might already have some extra micro USB cable lying around somewhere in your house anyway. All you have to do is connect the bigger end of the cable to the USB port of the laptop while plugging the smaller end of the cable to the DC IN 5v jack. You will see that your Bluetooth speaker is charging. Generally, a red led lights up when it is charging. You can find many online platforms selling power bank for charging your Bluetooth speaker.
How to Charge the JBL TUNE 220TWS and Check the Battery State?
There is plenty of new, wireless innovative technology that can charge your Bluetooth speaker. Check your Bluetooth model and see if it supports wireless charger. You can find an appropriate one for your speaker online. It can get a little tricky and technical. But with proper instruction, you can do it yourself. You will need:. Of course, a Bluetooth speaker preferably that has extra space inside to insert the coil.
Take out the printed circuit board PCB carefully especially considering the input line as the jack solder might not be strong.Then, the Xtreme plays for up to fifteen hours at average volume levels before needing another charge.
This AC adapter is black in color, as shown next. A detachable AC power cable connects the power converter box to a standard wall outlet. Input: volts, Hertz, 1. Output 19 volts DC, 3 amps Max.
Positive center on the DC output plug. Made in China. Power Supply. Energy verified. Other numbers found on the label: SU This AC cord comes in two pieces. Next, we show the AC input plug on that box. This is a pretty standard, non polarized AC cord. That means that you can insert the cord here either way.How To Charge A JBL Xtreme 2 Bluetooth Speaker
Also, the standard volt AC plug on the other end of the cable is non polarized. The end of the AC cord that plugs into the power supply is approximately five eights of an inch long and a quarter inch wide, as shown next. Now to the other connector in this power adapter. The part of the DC output jack the goes inside the speaker measures approximately 0. This DC plug has a notch near the tip to enhance secure holding when connected to the speaker, as seen in the last picture.
This plug is approximately three sixteenths of an inch wide, or roughly 5 mm. We claim no degree of precision on these measurements. You connect the AC power supply and speaker together via the DC cable and its barrel connector for recharging the internal batteries as shown next.
The Xtreme has one DC input plug, labeled Powerinside its port panel just beneath the orange zipper. See this port pointed out by the green arrow in the next picture. Skip to content. Like this: Like LoadingIn short, first, we recommend recharging the Xtreme with the included JBL charger. Presumably, JBL feels that this is a well-matched charger since they include it with the speaker. When you see the blinking red lamp, connect the black barrel DC output jack included with the speaker between the Xtreme and that power adapter.
Then, plug the adapter into a working wall outlet in order to recharge the speaker to full. Finally after a few hours, your JBL Xtreme speaker fully recharges. Grasp the orange zipper on the lower back of the Xtreem, and pull it to the left, opening port cover. This exposes the USB power out and charging input port inside, as shown next.
4 Savvy Ways to Charge Chromebook Without A Charger
At least one of the battery status lamps lights up on the Xtreme when you apply DC input power. There are five lamps on this Xtreme speaker that light in succession as internal battery charging progresses. Battery charging is almost complete when all but the last of the battery status lights light solid.
The last one continues to blink for several minutes more to top off the charge, as shown next. Note that unless this power port opening flap is zipped completely closed, water could enter the input and output connector ports area, and likely damage the Xtreme speaker components inside.
So, take special care to completely zip the port door closed on this speaker, to get full water resistance protection while not charging. Note that the battery charge status gauge just after turning on the Xtreme after a full recharge. All lamps are aglow, meaning that the speaker is current fully charged, as shown in the next picture. Repeat this process every fifteen hours of music play to keep its battery in good condition.
We charge ours when the battery status gauge lights show just one lamp glowing. An aging internal battery may cause this, as the battery can no longer deliver the minimum current the Xtreme needs to work properly.
Installing a new battery often solves this issue. We suggest though, that you consult a qualified electronics technician to install a new battery. The Xtreme speaker fully charges between three and four hours, depending on the state of the battery when recharging starts. This assumes that you use the charger that comes with the speaker.
Other wall chargers may take longer to fully recharge the Xtreme speaker. Press this button to shut it off. All lights should go out within a couple seconds. The speaker should also play that JBL trademark falling guitar cord sound.In short, first, we suggest that you charge the Xtreme with the included JBL charger.
Presumably, JBL thinks that this is a well-matched charger. After all, they do package it with the Xtreme. When you see the blinking red lamp, plug the black barrel DC output charge cord jack into the Xtreme. Then, plug the charger into a working wall outlet. Finally after a few hours, the Xtreme fully charges. Then, play it again for roughly fifteen hours before you have to charge it again.
Grasp the orange zipper on the lower back of the Xtreem, and pull it to the left, opening port cover. This exposes the USB power out and charge port inside, as shown next. Now that the Xtreme and its AC adapter are connected, we plug the charger into a functioning AC outlet, as shown next. At least one of the battery status lamps lights on the Xtreme when everything is working correctly.
Five lamps on this speaker light in succession as battery charge progresses. Battery charging is almost done when only the last of the battery status lights light is either OFF or blinking. The last then blinks for several minutes more to finish off the charge, as shown next. Note that unless you fully zip up this power port opening flap, water might enter the connector area.
It could then damage Xtreme components inside. So, take great care to fully close this port door for full water resistance. Note that the battery charge status gauge just after turning on the Xtreme after a full recharge.
All lamps are aglow, meaning that the speaker is current fully charged, as shown in the next picture. Repeat this process every fifteen hours of music play to keep its battery in good condition. We charge ours when the battery status gauge lights show just one lamp glowing. An aging internal battery may cause this, as the battery can no longer deliver the minimum current the Xtreme needs to work properly.
Installing a new battery often solves this issue. We suggest though, that you consult a qualified electronics technician to install a new battery. The Xtreme speaker fully charges between three and four hours, depending on the state of the battery when recharging starts.To summarize: First, select an adequate USB power adapter. Why this?
How to Charge Bluetooth Speaker Without a Charger?
Because the Flip 4 does not come with this as a standard accessory. Plus, the Flip 4 needs a high power USB power source to charge fully in a reasonable amount of time. Next, connect the orange micro USB cable between the Flip 4 and that adapter. Next, plug the adapter into a working wall outlet.
Use a penny or a dime to pry open the waterproof seal port cover on the Flip 4. This exposes the micro USB charging port inside, as shown next.
Then, plug the small end of the orange micro USB charge cord into the matching micro USB port in the speaker, as shown next. At least one of the battery status lamps lights up on the Flip 4 when you apply enough USB power. There are five lamps that light in succession as the speaker battery charging progresses, as shown in the next picture.
Battery charging is complete when all but the last of the battery status lights light solid. The last one continues to blink for several minutes.
This next picture shows the speaker just before completing a full charge cycle. Note that all the lamps in the battery status gage are glowing. However, the last one continues to blink. Note that unless this flap is snapped securely and completely in place, water could enter the port area, possibly damaging the Flip 4 electronics inside. So, be sure to press the port door closed with enough force to properly seat it, for full water resistance.
Please turn it on so that you can experience the full capabilities of this site. Wirelessly connect up to 2 smartphones or tablets to the speaker and take turns enjoying immersive stereo sound.
The built-in rechargeable Li-ion battery supports up to 15 hours of playtime and effortlessly charges your device via an USB port.
Take the Xtreme 2 to the beach or the pool without worrying about spills or even submersion in water. Take crystal clear calls from your speaker with the touch of a button thanks to the noise and echo cancelling speakerphone.
The durable fabric material and rugged rubber housing allows your speaker to outlast all of your adventures. A portable speaker that truly packs a punch — featuring upgraded drivers that offer big, bold sound. IPX7 waterproof design and durable fabric means this speaker is up for any adventure.
Just like you. This speaker starts the party and finishes it. Built with 15 hours of battery, because a full day should be full of sound. Harness the power of portable sound. Includes a carrying strap so you can bring it anywhere, and a bottle opener so you can celebrate when you get there. JBL Xtreme 2 is the ultimate portable Bluetooth speaker that effortlessly delivers dynamic and immersive stereo sound. The speaker is armed with four drivers, two JBL Bass Radiators, a rechargeable 10,mAh Li-ion battery supporting up to 15 hours of playtime.
On top of these, the speaker carries a convenient USB charge out. The speaker is IPX7 rated, featuring a waterproof design, with rugged fabric in exclusive colors complementing the Xtreme 2. The speaker carries integrated hooks, a durable metal base, and an added bottle opener to the carrying strap adding to the consumer convenience level whilst on the go. Not to forget it's just as well a perfect audio solution for any home. Whether in the living room, poolside, or tailgating for the big game, the JBL Xtreme 2 brings bold sound, wherever!